Introduce sw acceleration for tx path of IPIP tunnels relying on the
netfilter flowtable infrastructure.
This patch introduces basic infrastructure to accelerate other tunnel
types (e.g. IP6IP6).
IPIP sw tx acceleration can be tested running the following scenario where
the traffic is forwarded between two NICs (eth0 and eth1) and an IPIP
tunnel is used to access a remote site (using eth1 as the underlay device):
$ip addr show
6: eth0: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc noqueue state UP group default qlen 1000
link/ether 00:00:22:33:11:55 brd ff:ff:ff:ff:ff:ff
inet 192.168.0.2/24 scope global eth0
valid_lft forever preferred_lft forever
7: eth1: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc noqueue state UP group default qlen 1000
link/ether 00:11:22:33:11:55 brd ff:ff:ff:ff:ff:ff
inet 192.168.1.1/24 scope global eth1
valid_lft forever preferred_lft forever
8: tun0@NONE: <POINTOPOINT,NOARP,UP,LOWER_UP> mtu 1480 qdisc noqueue state UNKNOWN group default qlen 1000
link/ipip 192.168.1.1 peer 192.168.1.2
inet 192.168.100.1/24 scope global tun0
valid_lft forever preferred_lft forever
$ip route show
default via 192.168.100.2 dev tun0
192.168.0.0/24 dev eth0 proto kernel scope link src 192.168.0.2
192.168.1.0/24 dev eth1 proto kernel scope link src 192.168.1.1
192.168.100.0/24 dev tun0 proto kernel scope link src 192.168.100.1
Reproducing the scenario described above using veths I got the following
results:
- TCP stream trasmitted into the IPIP tunnel:
- net-next: (baseline) ~ 85Gbps
- net-next + IPIP flowtable support: ~102Gbps
Co-developed-by: Pablo Neira Ayuso <pablo@netfilter.org> Signed-off-by: Lorenzo Bianconi <lorenzo@kernel.org> Signed-off-by: Pablo Neira Ayuso <pablo@netfilter.org>